Commercial/Industrial Air Curtain Division

TDG info here

Climate Control with Direct Gas Heat is used in stopping cold drafts from entering while providing warm air produced by direct gas heaters.  The aire curtain pulls the air directly through the flame of the direct gas heater.  The TDG blankets the full length and width of the door with warm air.  The Climate Control with Direct Gas will discharge a temperature of 105° F, even if the entering air temperature is 0° F.  The TDG provides a maximum temperature rise of 105° F and can draw 100% inside air as long as the door is open.   This unit is commonly used where temperature is critical to maintain.  The TDG is recommended for doors up to ten feet tall (anything higher would require an industrial TSD or EHD).  The TDG has top and bottom access panels to replace or service motors or blowers without lowering entire unit or bottom half of unit.   All units are direct drive, which avoids misalignment of couplers and outboard bearings and eliminates periodic belt replacement.  The motor/blower plate comes out as an entire piece and all parts on the outside of the unit are constructed of stainless steel.

Downloadable Catalog PDF files:
Specifications
TDG Data Table
TDG Mechanical
Control Options
Door Switch Mountings
Installation Instructions