Commercial/Industrial Air Curtain Division

TIG

Climate Control with Indirect Gas Heat is used in stopping cold drafts from entering while providing warm air produced by indirect gas heaters.  The gas heater pushes air into the stainless steel duct transition and blankets the full width and length of door.  TIG provides a temperature rise of 33° F to the ambient entering air.  Closed combustion heaters are available upon request.  The TIG is recommended for doors up to ten feet tall (anything higher would require an industrial TSD or EHD).  The TIG has top and bottom access panels to replace or service motors or blowers without lowering entire unit or bottom half of unit.   All units are direct drive, which avoids misalignment of couplers and outboard bearings and eliminates periodic belt replacement.  The motor/blower plate comes out as an entire piece and all parts on the outside of the unit are constructed of stainless steel.

Downloadable Catalog PDF files:
Specifications
TIG Data Table
TIG Mechanical
Control Options
Door Switch Mountings
Installation Instructions